Show Mac Address-Table - Allied Telesis SwitchBlade x908 Series Software Reference Manual

show mac address-table

Use this command to display the mac address-table for all configured VLANs.
Syntax show mac address-table
Exec and Privileged Exec mode
Mode
The show mac address-table command is only applicable to view a mac address-table for
Usage
layer 2 switched traffic within VLANs.
To display the mac address-table, use the command:
Example
See the below sample output captured when there was no traffic being switched:
Output
See the sample output captured when packets were switched and mac addresses were learnt:
Note the new mac addresses learnt for port 1.0.9 and port 1.0.11 added as dynamic entries.
Note the first column of the output below shows VLAN IDs if multiple VLANs are configured:
C613-50007-01 REV B
awplus#
awplus#show mac address-table
VLAN port mac
1 unknown 0000.cd28.0752
ARP - 0000.cd00.0000
awplus#show mac address-table
VLAN port mac
1 unknown 0000.cd28.0752
1 port1.0.11 0030.846e.9bf4
1 port1.0.9 0030.846e.bac7
ARP - 0000.cd00.0000
awplus#show mac address-table
VLAN port mac
1 unknown 0000.cd28.0752
1 port1.0.9 0030.846e.bac7
2 unknown 0000.cd28.0752
2 port1.0.11 0030.846e.9bf4
ARP - 0000.cd00.0000
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
show mac address-table
type
forward
forward
type
forward
forward
forward
forward
type
forward
forward
forward
forward
forward
Switching Commands
static
static
static
dynamic
dynamic
static
static
dynamic
static
dynamic
static
15.27