How To Change The Password; How To Set A Management Ip Address - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Getting Started

How to change the password

To change the password for the manager account, enter Global Configuration mode and enter
the following command:
The password can contain any printable character and is case sensitive.

How to set a management IP address

This section describes how to set an IP address on the eth0 management port.
Step 1:
After logging in, enter Privileged Exec mode by using the command:
awplus>enable
Then check the current configuration by using one of the following commands:
This results in the following output:
This results in the following output:
Step 2:
Enter Global Configuration mode and enter the command:
Step 3:
Enter the command:
For example, to set the address to 172.28.8.210/16, enter the command:
1.16
awplus(config)#
If desired, check the current configuration
awplus#
Interface
eth0
awplus#
!
interface eth0
ip address 172.28.8.200/16
!
Enter Interface Configuration mode for the eth0 interface
awplus(config)#
Enter the IP address and mask
awplus(config-if)#
awplus(config-if)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
username manager password <new-password>
show ip interface eth0 brief
IP-Address Status
172.28.8.200 admin up
show running-config interface eth0
interface eth0
ip address <address/mask>
ip address 172.28.8.210/16
Protocol
running
C613-50007-01 REV B