Thrash-Limiting - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Switching Commands

thrash-limiting

Sets and configures the thrash limit action that will be applied to any port on the switch when a
thrashing condition is detected. The thrash-limiting timeout specifies the time, in seconds, for
which the thrash action is employed.
Syntax
thrash-limiting {[action {learn-disable|link-down|port-disable|
no thrash-limiting {action|timeout}
Parameter
thrash-limiting
action
learn-disable
link-down
port-disable
vlan-disable
none
timeout
<0-86400>
no
Interface Mode
Mode
To set the action to learn disable, use the command:
Example
To set the thrash limiting timeout to 5 seconds, use the command:
To set the thrash limiting action to its default, use the command:
To set the thrash limiting timeout to its default, use the command:
15.44
vlan-disable|none}][timeout <0-86400>]}
Description
set mac address thrash limiting
the mac thrashing detected action. The default is vlan-disable.
disable mac address learning
block all traffic on an interface - link down
block all traffic on an interface - link remains up
block all traffic on a vlan
Note that setting this parameter will also enable ingress filtering.
no thrash action
set the duration for the thrash action
the duration of the applied thrash action - in seconds. The default is 1
seconds.
sets either the selected thrash limiting action or its timeout to the
default value.
awplus# configure terminal
awplus(config)# interface port1.0.2
awplus(config-if)# thrash-limiting action learn-disable
awplus(config-if)# thrash-limiting timeout 5
awplus(config-if)# no thrash-limiting action
awplus(config-if)# no thrash-limiting timeout
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B