Distance (Rip) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

RIP Commands

distance (rip)

This command sets the administrative distance for RIP routes. Your device uses this value to
select between two or more routes to the same destination from two different routing
protocols. The route with the smallest administrative distance value is added to the Forwarding
Information Base (FIB). See
The no form sets the administrative distance for the RIP route to the default of 120.
Syntax distance <1-255> {<ip-address/m> [<access-list>]}
no distance <1-255> {<ip-address/m> [<access-list>]}
Parameter
<1-255>
<ip-address/m>
<access-list>
Router mode
Mode
To set the administrative distance to 8 for the RIP routes within the 10.0.0.0/8 network that
Examples
match the access-list mylist, use the commands:
awplus(config-router)#
To set the administrative distance to the default of 120 for the RIP routes within the 10.0.0.0/8
network that match the access-list "mylist", use the commands:
awplus(config-router)#
32.6
"Administrative Distance" on page 29.4
Description
The administrative distance value you are setting for this RIP route.
The network prefix that you are changing the administrative distance
for. Enter an IPv4 address in the format A.B.C.D/M: dotted decimal
notation followed by a forward slash, and then the subnet mask length.
Specifies the access-list name. This access list specifies which routes
within the network <ip-address/m> this command applies to.
awplus(config)# router rip
distance 8 10.0.0.0/8 mylist
awplus(config)# router rip
no distance 8 10.0.0.0/8 mylist
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
for more information.
C613-50007-01 REV B