Show Ip Route - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Routing Commands

show ip route

Use the show ip route command to display the current state of the routing table.
This command displays the routes in the FIB. The FIB contains the best routes to a destination,
and your device uses these routes when forwarding traffic. You can use this command to view
a subset of the FIB based on protocol or network.
To modify the lines displayed, use the | (output modifier token); to save the output to a file,
use the > output redirection token.
Syntax show ip route [bgp|connected|ospf|rip|static|<ip-address>|<ip-
Parameter
bgp
connected
ospf
rip
static
<ip-address>
<ip-address/m>
Exec mode and Privileged Exec mode
Mode
Each entry in this table has a code preceding it, indicating the source of the routing entry. For
Output
example, O indicates OSPF as the origin of the route. The first few lines of the output list the
possible codes that may be seen with the route entries.
Typically, route entries are composed of the following elements:
■
■
■
■
■
■
■
30.4
address/m>]
Description
Displays only the routes learned from BGP.
Displays only the routes learned from connected interfaces.
Displays only the routes learned from OSPF.
Displays only the routes learned from RIP.
Displays only the static routes you have configured.
Displays the routes for the specified address. Enter an IPv4 address in
dotted decimal notation, in the form A.B.C.D.
Displays the routes for the specified network. Enter an IPv4 address
in dotted decimal notation A.B.C.D/M.
code
a second label indicating the sub-type of the route
network or host ip address
administrative distance and metric
nexthop ip address
outgoing interface name
time since route entry was added
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B