Show Running-Config Interface - Allied Telesis SwitchBlade x908 Series Software Reference Manual

show running-config interface

show running-config interfaceCommand
This command displays the current configuration of one or more interfaces on the switch.
For information on output options, see
Syntax
show running-config interface [<interface-list>]
Parameter
<interface-list>
dot1x
lacp
ip igmp
ip multicast
ip pim sparse-mode
ip pim dense-mode displays running configuration for PIM-DM (Protocol Independent
mstp
ospf
rip
ipv6 rip
rstp
stp
Privileged Exec mode
Mode
C613-50007-01 REV B
New vs_531 %flag
[dot1x|ip igmp|ip multicast|ip pim dense-mode|ip pim sparse-mode|
ipv6 rip|lacp|mstp|ospf|rip|rstp|stp]
Description
The interfaces or ports to display information about. An interface-
list can be:
■
■
■
The specified interfaces must exist.
displays running configuration for 802.1X port authentication for
the specified interfaces.
displays running configuration for LACP (Link Aggregation
Control Protocol) for the specified interfaces.
displays running configuration for IGMP (Internet Group
Management Protocol) for the specified interfaces.
displays running configuration for general multicast settings for the
specified interfaces.
displays running configuration for PIM-SM (Protocol Independent
Multicast - Sparse Mode) for the specified interfaces.
Multicasting - Dense Mode) for the specified interfaces.
displays running configuration for MSTP (Multiple Spanning Tree
Protocol) for the specified interfaces.
displays running configuration for OSPF (Open Shortest Path
First) for the specified interfaces.
displays running configuration for RIP (Routing Information
Protocol) for the specified interfaces.
displays running configuration for RIPng (RIPng for IPv6) for the
specified interfaces.
displays running configuration for RSTP (Rapid Spanning Tree
Protocol) for the specified interfaces.
displays running configuration for STP (Spanning Tree Protocol)
for the specified interfaces.
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
File Management Commands This command displays the current configuration of one or more interfaces on the switch.
"Controlling "show" command output" on page
an interface, a switch port, or a channel group (e.g., vlan2,
port1.1.12, sa3, or po4)
a contiguous range of interfaces, ports, or channel groups
separated by a hyphen,
e.g. vlan2-vlan8 or port1.1.1-port1.1.24 or sa2-4, po1-3
a comma-separated list of the above,
e.g., port1.0.1,port1.1.1-1.2.24. Do not mix interface types in a
list.
File Management Commands
1.30.
7.31