Ipv6 Nd Other-Config-Flag - Allied Telesis SwitchBlade x908 Series Software Reference Manual

ipv6 nd other-config-flag

ipv6 nd other-config-flag Command
Use this command to set the other stateful configuration flag (contained within the router
advertisement field) to be used for IPv6 address auto-configuration. This flag is used to request
the router to provide information in addition to providing addresses.
Note:
Use no parameter with this command to reset the value to default.
Syntax
ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Unset
Default
Interface mode
Mode
Advertisement flags will not be transmitted unless you have applied the
Usage
command on page
To set the ipv6 other-config-flag on vlan4, use the following commands:
Example
awplus(config-if)#
awplus(config-if)#
ipv6 nd suppress-ra
Related Commands
ipv6 nd prefix
ipv6 nd managed-config-flag
C613-50007-01 REV B
New vs_531 %flag
Setting the
ipv6 nd managed-config-flag command on page 25.4
nd other-config-flag will also be set.
25.10. This step is included in the example below.
awplus# configure terminal
awplus(config)# interface vlan4
ipv6 nd other-config-flag
no ipv6 nd suppress-ra
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6 Commands This new command is used to set the other stateful configuration flag (contained within the router advertisement field) to be used for IPv6 address auto-configuration.
IPv6 Commands
implies that the
ipv6
no ipv6 nd suppress-ra
25.5