Spanning-Tree Enable - Allied Telesis SwitchBlade x908 Series Software Reference Manual

spanning-tree enable

Use this command to enable or disable the spanning tree protocol for the configured spanning
tree mode on the device. Use the no parameter to disable the configured spanning tree
protocol on the device.
Syntax
spanning-tree {mstp|rstp|stp} enable
no spanning-tree {mstp|rstp|stp} enable
Parameter
mstp
rstp
stp
Global Configuration mode
Mode
The configured spanning tree mode is enabled by default.
Default
Examples
awplus(config)#
awplus(config)#
C613-50007-01 REV B
Description
Enables MSTP
Enables RSTP
Enables STP
awplus# configure terminal
spanning-tree mstp enable
awplus# configure terminal
no spanning-tree mstp enable
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Spanning Tree Commands
19.25