Show System - Allied Telesis SwitchBlade x908 Series Software Reference Manual

System Configuration and Monitoring Commands

show system

This command displays general system information about the device, including the hardware
installed, memory, and software versions loaded. It also displays location and contact details
when these have been set.
For a stacked configuration, if this command is entered on the stack master, it will display the
information for all the stack members. A stack member heading will be displayed to distinguish
the different information for every stack member.
If it is entered on a specific stack member, as a host-directed command, it will display the
information for that stack member.
Syntax
show system
Exec mode and Privileged Exec mode
Mode
To display the system information for a single switch, or a whole stack, use the command:
Example
To display the system information of stack member 3, use the command:
Figure 8-9: Example output from the show system command
Output
Switch System Status
Board ID Bay
--------------------------------------------------------------------------------
Base 219
--------------------------------------------------------------------------------
Memory: DRAM: 255196 kB
--------------------------------------------------------------------------------
Environment Status : Normal
Uptime
Bootloader version : 1.0.9
Current software
Software version
Build date
Current boot config: flash:/default.cfg (file exists)
Territory
System Name
System Contact
System Location
8.30
awplus#
awplus#
Board Name
AT-9924T-EMC
Flash: 30.0MB Used: 26.4MB Available: 3.6MB
: 25 days 11:41:58
: r2-main-20071011-1.rel
: main 20071011-1
: Thu Oct 11 02:41:04 NZDT 2007
: usa
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
show system
remote-command 3 show system
Wed Dec 19 08:42:16 2007
Rev Serial number
A-0 61556953
C613-50007-01 REV B