Clear Ip Bgp (Ip Address) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

clear ip bgp (ip address)

Use this command to reset the IPv4 BGP connection to the peer specified by the IP address.
Syntax clear ip bgp <ip-address> [<in>|out|<soft>]
clear ip bgp <ip-address> ipv4 <prefix> <routes>
Parameter
<ip-address>
ipv4
<routes>
<in>
in
prefix-filter
out
<soft>
in
out
<prefix>
unicast
multicast
Privileged Exec mode
Mode
Example
awplus#
awplus#
awplus#
C613-50007-01 REV B
Description
Specifies the IPv4 address of the neighbor whose connection is to be
reset, entered in the form A.B.C.D.
Clears all IPv4 address family peers. Configure parameters relating to the
BGP exchange of IPv4 prefixes.
{IN|out|soft}
in [prefix-filter]
Indicates that incoming advertised routes will be cleared
Specifies that a prefix-list will be sent, by the ORF mechanism, to those
neighbors with which the ORF capability has been negotiated. The
neighbors will be triggered to resend updates, which match the prefix-
list filter, to the local router. The local router will then perform a soft
reconfiguration.
Indicates that outgoing advertised routes will be cleared.
soft [in |out]
Soft inbound reset causes the neighbors to resend all their updates to
the local switch, without resetting the connection or clearing the entries
in the local switch. So, the local switch stores new updates, and uses
them to systematically replace existing table entries. This process can
use a considerable amount of memory.
Soft outbound reset causes the switch to simply resend all its updates to
the specified neighbor(s), without resetting the connection, or clearing
table entries.
{unicast|multicast}
unicast address family modifier. Configure parameters relating to the
BGP exchange of routes to unicast destinations.
multicast address family modifier. Configure parameters relating to the
BGP exchange of routes to multicast sources.
clear ip bgp 192.0.2.12 soft
clear ip bgp 192.0.2.5 ipv4 unicast out
clear ip bgp 192.0.2.11
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
BGP Commands
38.37