Platform Jumboframe - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Switching Commands

platform jumboframe

This command enables the device to forward jumbo frames. For more information, see
"Support for Jumbo Frames" on page 14.16.
When jumbo frame support is enabled, the maximum size of packets that the device can
forward is:
■
■
You must restart the device after entering this command for it to take effect. You can use the
the
The no parameter disables the device from forwarding jumbo frames. This stops the ports from
forwarding packets larger than VLAN tagged frames (1522 bytes).
You must restart the device after entering this command for it to take effect.
This feature is disabled by default.
Syntax
platform jumboframe
no platform jumboframe
By default, jumbo frames is off.
Default
Global Configuration mode
Mode
To enable the device to forward jumbo frames, use the command:
Example
show platform
Related Commands
show running-config
15.20
9710 bytes for ports that work at speeds of either 10Mbps or 100Mbps
10240 bytes for ports that work at speeds of 1000Mbps is 10240 bytes.
reboot command on page 83.4
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
to restart the device.
platform jumboframe
C613-50007-01 REV B