Clear Ip Bgp - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands

clear ip bgp *

Use this command to reset all BGP connections - either by fully resetting sessions, or by
performing soft resets.
Syntax
clear ip bgp * [<in>|out|<soft>]
Parameter
*
<in>
in
prefix-filter
out
<soft>
in
out
Privileged Exec mode
Mode
Example
38.36
Description
Clears connections with all BGP peers
in [prefix-filter]
Indicates that incoming advertised routes will be cleared
Specifies that a prefix-list will be sent, by the ORF mechanism, to
those neighbors with which the ORF capability has been
negotiated. The neighbors will be triggered to resend updates,
which match the prefix-list filter, to the local router. The local
router will then perform a soft reconfiguration.
Indicates that outgoing advertised routes will be cleared.
soft [in |out]
Soft inbound reset causes the neighbors to resend all their updates
to the local switch, without resetting the connection or clearing the
entries in the local switch. So, the local switch stores new updates,
and uses them to systematically replace existing table entries. This
process can use a considerable amount of memory.
Soft outbound reset causes the switch to simply resend all its
updates to the specified neighbor(s), without resetting the
connection, or clearing table entries.
awplus# clear ip bgp *
awplus# clear ip bgp * ipv4 unicast in prefix-filter
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B