Set Tag - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Route Map Commands

set tag

Use this command to add a tag set clause to a route map entry.
When a route matches the route map entry, the device sets its tag to the specified value when
it redistributes the route into OSPF.
Use the no parameter to remove the set clause.
Syntax
set tag <tag-value>
no set tag [<tag-value>]
Parameter
<tag-value>
Route-map mode
Mode
This command is valid only when redistributing routes into OSPF.
Usage
To use entry 3 of the route map called rmap1 to tag matching routes with the number 6, use
Examples
the commands:
awplus(config-route-map)#
default-information originate
Related Commands
redistribute
match tag
route-map
show route-map
39.36
Description
<0-4294967295>
Value to tag matching routes with.
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map rmap1 permit 3
set tag 6
C613-50007-01 REV B