Spanning-Tree Edgeport (Rstp And Mstp) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Spanning Tree Commands

spanning-tree edgeport (RSTP and MSTP)

Use this command to set a port as an edge-port.
Use this command for RSTP or MSTP.
This command has the same effect as the
configuration displays differently in the output of some show commands.
Use the no parameter with this command to set a port to its default state (not an edge-port).
Syntax
spanning-tree edgeport
no spanning-tree edgeport
Not an edge port.
Default
Interface mode
Mode
Use this command on a switch port connected to a LAN that has no other bridges attached. If
Usage
a BPDU is received on the port that indicates that another bridge is connected to the LAN,
then the port is no longer treated as an edge port.
Example
awplus(config-if)#
spanning-tree autoedge (RSTP and MSTP)
Related commands
19.24
awplus# configure terminal
awplus(config)# interface port1.1.2
spanning-tree edgeport
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
spanning-tree portfast command, but the
C613-50007-01 REV B