Service Test - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Interface Testing Commands

service test

This command puts the device into the interface testing state, ready to begin testing. After
entering this command, enter Interface Configuration mode for the desired interfaces and enter
the command test interface.
Do not test interfaces on a device that is part of a live network—disconnect the device first.
Use the no parameter to stop the test service.
Syntax
service test
no service test
Global Configuration mode
Mode
To put the device into a test state, use the command:
Example
awplus(config)# service test
test interface
Related Commands
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
C613-50007-01 REV B AlliedWare Plus Operating System - Software Version 5.3.1 13.3