Region (Mstp) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

region (MSTP)

Use this command to assign a name to the device's MST Region. MST Instances (MSTI) of a
region form different spanning trees for different VLANs.
Use this command for MSTP only.
Use the no version of the command to remove this region name and reset it to the default.
Syntax
region <region-name>
no region
Parameter
<region-name>
MST Configuration mode
Mode
By default, the region name is My Name.
Default
The region name, the revision number, and the digest of the VLAN to MSTI configuration
Usage
table must be the same on all devices that are intended to be in the same MST region.
Examples
awplus(config-mst)#
revision (MSTP)
Related Commands
show spanning-tree mst config
C613-50007-01 REV B
Description
Specify the name of the region, up to 32 characters. Valid characters are
upper-case, lower-case, digits, underscore.
awplus# configure terminal
awplus(config)# spanning-tree mst configuration
region ATL
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Spanning Tree Commands
19.9