Switchport Enable Vlan; Switchport Port-Security - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Switching Commands

switchport enable vlan

Enables you to manually re-enable a port in a VLAN.
Syntax switchport enable vlan [<1-4094>]
Parameter
switchport
enable
vlan
<1-4094>
The default VLAN is VLAN ID 1
Default
Interface mode
Mode
This command can be used where a VLAN disabled by certain actions, such as QoS Storm
Usage
Protection (QSP) or EPSR. If VID is not given, all the disabled VLANs will be re-enabled.
To re-enable the port1.1.1 in vlan 2:
Example

switchport port-security

Enables the port-security feature. This feature is also known as port-based learn limit. It allows
the user to set the maximum number of MAC addresses that each port can learn.
Use the no switchport port-security command to disable the port-security feature.
Syntax switchport port-security
no switchport port-security
Parameter
no
switchport
port-security
Interface Mode
Mode
To enable the port-security, use command:
Example
To disable port-security, use command:
15.40
Description
Switchport
Re-enables the vlan on the port
Re-enables the vlan on the port
VLAN ID
awplus(config)# interface port1.1.1
switchport enable vlan 2
awplus(config-if)#
Description
Negate a command or set its defaults
Set the switching characteristics of the Layer2 interface
Port-based learning limits
awplus(config-if)# switchport port-security
awplus(config-if)# no switchport port-security
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B