Bgp Rfc1771-Strict; Bgp Router-Id - Allied Telesis SwitchBlade x908 Series Software Reference Manual

bgp rfc1771-strict

Use this command to set the Strict RFC1771 setting.
Use the no parameter with this command to revert this setting.
Syntax
bgp rfc1771-strict
no bgp rfc1771-strict
Disabled
Default
Global Configuration mode
Mode
Example
awplus(config)#

bgp router-id

Use this command to configure the router identifier.
Use the no parameter with this command to disable this function.
Syntax
bgp router-id <routerid>
no bgp router-id [<routerid>]
Parameter
<routerid>
In case the loopback interface is configured the router-id is set to the IP address of a loopback
Default
interface. If not, the highest IP address is the router-id.
Router mode
Mode
Use bgp router-id command to manually configure a fixed router ID as a BGP router
Usage
identifier.
To configure a router ID with an IP address for a BGP router identifier, issue the commands
Example
listed below:
awplus(config-router)#
C613-50007-01 REV B
awplus# configure terminal
bgp rfc1771-strict
Description
A.B.C.D
Specifies the IP address without mask for a manually configured router ID.
awplus# configure terminal
awplus(config)# router bgp 100
bgp router-id 1.1.2.3
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
BGP Commands
38.27