Set Atomic-Aggregate - Allied Telesis SwitchBlade x908 Series Software Reference Manual

set atomic-aggregate

Use this command to add an atomic aggregate set clause to a route map entry.
When a BGP update message matches the route map entry, the device adds the atomic
aggregate attribute to the update.
Use the no parameter to remove the set clause.
Syntax
set atomic-aggregate
no set atomic-aggregate
Route-map mode
Mode
This command is valid for BGP update messages only.
Usage
To use entry 3 of the route map called rmap1 to add the atomic aggregator attribute to
Examples
matching update messages, use the commands:
awplus(config-route-map)#
route-map
Related Commands
show route-map
C613-50007-01 REV B
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map rmap1 permit 3
set atomic-aggregate
Route Map Commands
39.21