Introduction - Allied Telesis SwitchBlade x908 Series Software Reference Manual

RIPng Commands

Introduction

RIPng Commands Feature
This chapter contains AlliedWare Plus
Protocol next generation) is an extension of RIPv2 to support IPv6. RFC 2080 specifies RIPng.
The differences between RIPv2 and RIPng are:
■
■
■
aggregate-address
aggregate-address Command
Use this command to aggregate RIPng routes.
Use the no parameter with this command to disable this feature.
Syntax
aggregate-address <ipv6-addr/prefix-length>
no aggregate-address <ipv6-addr/prefix-length>
Parameter
<ipv6-addr/prefix-length>
Router mode
Mode
Example
awplus(config-router)#
34.2
New vs_531%flag RIPng Commands
RIPng does not support RIP updates authentication
RIPng does not allow the attachment of arbitrary tags to routes
RIPng requires the encoding of the next-hop for a set of routes
New vs_531 %flag
awplus# configure terminal
awplus(config)# router ipv6 rip
aggregate-address 3ffe:8088::/32
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
RIPng is a new feature of this software release
The
TM
RIPng commands. RIPng (Routing Information
RIPng Commands Use this command to aggregate RIPng routes.
Description
Specify the IPv6 Address in format X:X::X:X/Prefix-Length.
The prefix-length is a decimal integer between 1 and 128.
.
C613-50007-01 REV B