Chapter 15. Switching Commands; Introduction; Clear Loop-Protection Counters - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Switching Commands

Introduction

This chapter provides an alphabetized reference for each of the Switching Commands.

clear loop-protection counters

clear loop-protection countersCommand
Use this command to clear the counters for the Loop Protection counters.
Syntax
clear loop-protection [interface <ifrange>] counters
Parameters
interface
Exec and Privileged Exec mode
Mode
To clear the counter information:
Example
15.2
new vs_531 %flag
Description
The interface whose counters are to be cleared.
<ifrange>
awplus # clear loop-protection counters
awplus # clear loop-protection interface port1.0.1
counters
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Switching Commands This is one of several new loop protection commands.
A port, a port range, or an aggregated link.
C613-50007-01 REV B