Ip Domain-Lookup - Allied Telesis SwitchBlade x908 Series Software Reference Manual

IP Addressing and Protocol Commands

ip domain-lookup

This command enables the DNS client on your device. This allows you to use domain names
instead of IP addresses in commands. The DNS client resolves the domain name into an IP
address by sending a DNS enquiry to a DNS server, specified with the
command.
The client is enabled by default. However, it does not attempt DNS enquiries unless there is a
DNS server configured.
The no parameter disables the DNS client. The client will not attempt to resolve domain
names. You must use IP addresses to specify hosts in commands.
Syntax
ip domain-lookup
no ip domain-lookup
Global Configuration mode
Mode
To enable the DNS client on your device, use the commands:
Examples
To disable the DNS client on your device, use the commands:
ip domain-list
Related Commands
ip domain-name
ip name-server
show hosts
show ip name-server
23.10
awplus# configure terminal
awplus(config)# ip domain-lookup
awplus# configure terminal
awplus(config)# no ip domain-lookup
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
ip name-server
C613-50007-01 REV B