BGP Commands
bgp bestpath as-path ignore
This command prevents the router from considering as-path as a factor in the algorithm for
choosing a route.
The no form allows the router to consider as-path in choosing a route.
Syntax
bgp bestpath as-path ignore
no bgp bestpath as-path ignore
Router mode
Mode
Example
awplus(config-router)#
bgp always-compare-med
Related Commands
bgp bestpath med
bgp bestpath compare-routerid
bgp bestpath compare-confed-aspath
This command specifies that the AS confederation path length must be used, when available, in
the BGP best path decision process. It is effective only when bgp bestpath as-path ignore
command has not been specified.
By default, if BGP receives routes with identical eBGP paths from eBGP peers, BGP does not
continue to consider any AS confederation path length attributes that may be associated with
the routes.
The no bgp bestpath compare-confed-aspath command returns the switch to the
default state, where the switch ignores AS confederation path length in the BGP best path
selection process.
Syntax
bgp bestpath compare-confed-aspath
no bgp bestpath compare-confed-aspath
Router mode
Mode
Example
awplus(config-router)#
bgp bestpath as-path ignore
Related Commands
38.8
awplus#
configure terminal
awplus(config)#
router bgp 100
bgp bestpath as-path ignore
awplus#
configure terminal
awplus(config)#
router bgp 100
bgp bestpath compare-confed-aspath
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus
Operating System - Software Version 5.3.1
C613-50007-01 REV B