Ip Ospf Hello-Interval - Allied Telesis SwitchBlade x908 Series Software Reference Manual

ip ospf hello-interval

This command specifies the interval between hello packets.
The hello-interval is advertised in the hello packets. Configure the same hello-interval for all
routers on a specific network. A shorter hello interval ensures faster detection of topological
changes, but results in more routing traffic.
The no form of this command returns the interval to the default of 10 seconds.
Syntax
ip ospf [<ip_address>] hello-interval <1-65535>
no ip ospf [<ip_address>] hello-interval
Parameter
<ip_address>
<1-65535>
Interface mode
Mode
The following example shows setting the hello-interval to 3 seconds on interface VLAN2.
Examples
ip ospf dead-interval
Related Commands
show ip ospf interface
C613-50007-01 REV B
Description
The IP address of the interface, in dotted decimal notation.
The interval in seconds.
Default: 10
awplus# configure terminal
awplus(config)# interface VLAN2
awplus(config-if)# ip ospf hello-interval 3
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
OSPF Commands
36.33