Neighbor Allowas-In - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor allowas-in

Use this command to accept an AS-path with the specified Autonomous System (AS) number
from inbound updates.
Use the no parameter with this command to revert to default.
Syntax
neighbor <neighborid> allowas-in <occurrences>
no neighbor <neighborid> allowas-in
Parameter
<neighborid>
<occurrences>
Disabled
Default
Use this command to configure PE routers to allow re-advertisement of all prefixes containing
Usage
duplicate Autonomous System Numbers (ASNs).
In a hub and spoke configuration, a PE router re-advertises all prefixes containing duplicate
ASNs.
Specify the remote-as or peer-group first using the related commands.
Router mode and Address Family [ipv4 unicast | ipv4 multicast] mode
Mode
Example
awplus(config-router)#
awplus(config-router-af)#
neighbor remote-as
Related Commands
neighbor peer-group (creating a peer-group)
neighbor peer-group (adding a neighbor)
C613-50007-01 REV B
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
<1-10> Specifies the number of occurrences of the AS number.
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.0.1 allowas-in 3
awplus#
awplus(config)#
awplus(config-router)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted decimal
notation A.B.C.D.
Name of an existing peer-group. For information on how to
create peer groups, refer to the
(adding a neighbor) command on page
neighbor remote-as command on page
When this parameter is used with a command, the
command applies on all peers in the specified group.
configure terminal
router bgp 10
address-family ipv4
neighbor 10.10.0.1 allowas-in 3
BGP Commands
neighbor peer-group
38.75, and
38.79.
38.55