Ip Rip Send Version 1-Compatible; Ip Rip Split-Horizon - Allied Telesis SwitchBlade x908 Series Software Reference Manual

RIP Commands

ip rip send version 1-compatible

Use this command to send RIP version 1 compatible packets from a version 2 RIP interface.
This mechanism causes version 2 RIP to broadcast the packets instead of multicasting them.
Use the no parameter with this command to use the global RIP version control rules.
Syntax
ip rip send version 1-compatible
Disabled
Default
Interface mode
Mode
In the following example, interface VLAN2 is configured to send RIP version 1-compatible
Example
packets; so it broadcasts both RIP version 1 and 2 packets.
awplus(config-if)#

ip rip split-horizon

Use this command to perform the split-horizon action on the interface. The default is split-
horizon poisoned.
Use the no parameter with this command to disable this function.
Syntax ip rip split-horizon [poisoned]
no ip rip split-horizon
Parameter
poisoned
Split horizon poisoned is the default.
Default
Interface mode
Mode
Use this command to avoid including routes in updates sent to the same gateway from which
Usage
they were learned. Using the split horizon command omits routes learned from one
neighbor, in updates sent to that neighbor. Using the poisoned parameter with this command
includes such routes in updates, but sets their metrics to infinity. Thus, advertising that these
routes are not reachable.
Example
awplus(config-if)#
32.18
awplus# configure terminal
awplus(config)# interface VLAN2
ip rip send version 1-compatible
Description
Performs split-horizon with poisoned reverse.
awplus# configure terminal
awplus(config)# interface VLAN2
ip rip split-horizon poisoned
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B