Distribute-List (Ipv) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

RIPng Commands
distribute-list (IPv6)
distribute-list (IPv6) Command
Use this command to filter incoming or outgoing route updates using the access-list or the
prefix-list.
Use the no parameter with this command to disable this feature.
Syntax
distribute-list [<access-list>|prefix <prefix-list-name>]
no distribute-list [<access-list>|prefix <prefix-list-name>]
Parameter
<access-list>
<prefix-list-name>
<ifname>
in
out
Disabled
Default
Router mode
Mode
Filter out incoming or outgoing route updates using the access-list or the prefix-list. If you do
Usage
not specify the name of the interface, the filter is applied to all the interfaces.
Example
awplus(config-router)#
ipv6 access-list extended (Named)
Related Commands
ipv6 access-list standard (Named)
ipv6 nd prefix
34.6
New vs_531 %flag
[in|out][<ifname>]
[in|out][<ifname>]
Description
Optional. Specifies the IPv6 access-list number or name to use.
Optional. Filter prefixes in routing updates.
Specify the name of the IPv6 prefix-list to use.
Optional. Specifies the name of the interface for which
distribute-list applies.
Optional. Filter incoming routing updates.
Optional. Filter outgoing routing updates.
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
RIPng Commands Use this command to filter incoming or outgoing route updates using the access-list or the prefix-list.
configure terminal
router ipv6 rip
distribute-list prefix myfilter in vlan2
C613-50007-01 REV B