Switchport Private-Vlan Mapping - Allied Telesis SwitchBlade x908 Series Software Reference Manual

switchport private-vlan mapping

Use this command to associate a primary VLAN and a set of secondary VLANs to a
promiscuous port.
Use the no form of this to remove all the association of secondary VLANs to primary VLANs
for a promiscuous port.
Syntax
switchport private-vlan mapping <primary-vlan-id> add
switchport private-vlan mapping <primary-vlan-id> remove
no switchport private-vlan mapping
Parameter
<primary-vlan-id>
<secondary-vid-list>
Interface mode
Mode
This command can be applied to a switch port or a static channel group, but not a dynamic
Usage
(LACP) channel group. LACP channel groups (dynamic/LACP aggregators) cannot be
promiscuous ports in private VLANs.
Example
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
switchport mode private-vlan
Related Commands
C613-50007-01 REV B
<secondary-vid-list>
<secondary-vid-list>
Description
VLAN ID of the primary vlan
VLAN ID of the secondary vlan (either isolated or community),
or a range of VLANs, or a comma-separated list of VLANs and
ranges.
awplus# configure terminal
awplus(config)# interface port1.0.2
switchport private-vlan mapping 2 add 3-4
switchport private-vlan mapping 2 remove 3-4
no switchport private-vlan mapping
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
VLAN Commands
17.13