Debug Platform Packet - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Switching Commands

debug platform packet

This command enables platform to CPU level packet debug.
This command can be used to trace packets sent and received by the CPU. If a timeout is not
specified, then a default 5 minute timeout will be applied. If a timeout of 0 is specified, packet
debug will be generated until the no debug platform packet command is used or another
timeout value is specified. The timeout value applies to both send and receive debug and is
updated whenever the debug platform packet command is used.
Use the no debug platform packet command to disable platform to CPU level packet
debug. If the result means both send and receive packet debug are disabled, then any active
timeout will be cancelled.
Syntax
debug platform packet [recv|send] [timeout <0-3600>]
no debug platform packet [recv|send]
Parameter
recv
send
timeout
<0-3600>
Privileged Exec mode and Global Configuration mode
Mode
To enable both receive and send packet debug for the default 5 minutes:
Example
To enable receive packet debug for 10 seconds:
To enable send packet debug with no timeout:
To disable receive packet debug:
15.6
Description
Debug packets received.
Debug packets sent.
Stop debug after a specified time.
The timeout period, specified in seconds.
awplus# debug platform packet
awplus# debug platform packet recv timeout 10
awplus# debug platform packet send timeout 0
awplus# no debug platform packet recv
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B