Chapter 13. Interface Testing Commands; Introduction; Clear Test Interface - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Interface Testing Commands

Introduction

This chapter provides an alphabetical reference of AlliedWare Plus
interfaces.

clear test interface

This command clears test results and counters after issuing a test interface command. Test
results and counters must be cleared to issue subsequent test interface commands later on.
Syntax
clear test interface {<port-list>|all}
Parameter
clear
test
interface
<port-list>
all
Privileged Exec mode
Mode
To clear the counters for port1.0.1 use the command:
Examples
To clear the counters for all interfaces use the command:
To clear the counters for ports 1 to 12 on XEM 1 (port1.1.1 through port1.1.12) apply:
test interface
Related Commands
13.2
Description
Resets functions
Test device functionality
Test interface
The ports to clear test results and counters for. A port-list can be:
a switch port (e.g. port1.1.12)
■
a continuous range of ports, (e.g. port1.1.1-port1.1.24)
■
a comma-separated list of the above,
■
e.g., port1.0.1,port1.1.1-1.2.24.
The specified ports must exist.
All interfaces
awplus# clear test interface port1.0.1
awplus# clear test interface all
awplus# clear test interface port1.1.1-port1.1.12
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
TM
OS commands for testing
C613-50007-01 REV B