Set Metric-Type - Allied Telesis SwitchBlade x908 Series Software Reference Manual

set metric-type

Use this command to add a metric-type set clause to a route map entry.
When a route matches the route map entry, the device sets its route type to the specified
value.
Use the no parameter to remove the set clause.
Syntax
set metric-type {type-1|type-2}
no set metric-type [type-1|type-2]
Parameter
type-1
type-2
Route-map mode
Mode
This command is valid for OSPF routes only.
Usage
To use entry 3 of the route map called rmap1 to redistribute matching routes into OSPF as
Examples
type-1 external routes, use the commands:
awplus(config-route-map)#
default-information originate
Related Commands
redistribute
match route-type
route-map
show route-map
C613-50007-01 REV B
Description
Redistribute matching routes into OSPF as type-1 external routes.
Redistribute matching routes into OSPF as type-2 external routes.
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map rmap1 permit 3
set metric-type 1
Route Map Commands
39.33