Show Telnet; Show Users - Allied Telesis SwitchBlade x908 Series Software Reference Manual

User Access Commands

show telnet

show telnet Command
This command shows the Telnet server settings.
Syntax show telnet
Exec mode and Privileged Exec mode.
Mode
To show the Telnet server settings use the command:
Example
Figure 5-1: Example output from the show telnet command
Output
clear line vty
Related Commands
service telnet

show users

telnet server
show users
This command shows information about the users who are currently logged into the device.
Syntax
show users
Exec mode and Privileged Exec mode.
Mode
Figure 5-2: Example output from the show users command
Output
Line User
con 0 manager
vty 0 bob
To show the users currently connected to the device, use the command:
Example
5.12
Modified vs_531 %flag
awplus# show telnet
Telnet Server Configuration
------------------------------------------------------------
Telnet server
Protocol
Port
Host(s)
idle
idle
awplus#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
User Access Commands Updated telnet command for IPv6 addressing.
: Enabled
: IPv4,IPv6
: 23
Idle
00:00:00
00:00:03
show users
Location
ttyS0
172.16.11.1
C613-50007-01 REV B