Log Email (Filter) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Logging Commands

log email (filter)

Creates a filter to select messages to be sent to an email address. Selection can be based on
the priority/ severity of the message, the program that generated the message, the logging
facility used, a sub-string within the message or a combination of some or all of these.
The no log email to command configures the device to no longer send log messages to
a specified email address. All configuration relating to this log target will be removed.
Syntax log email <email-address>
no log email <email-address>
Parameter
log
email
<email-address>
no
level
<level>
10.18
[level <level>]
[program <program-name>]
[facility <facility>]
[msgtext <text-string>]
[level <level>]
[program <program-name>]
[facility <facility>]
[msgtext <text-string>]
Description
Logging control
Set email logging parameters
The email address to send logging messages to
Deletes the specified filter, so that corresponding messages are no
longer sent to the specified email address.
Filter messages by severity level.
The minimum severity of messages to send. The level can be
specified as one of the following numbers or level names, where 0 is
the highest severity and 7 is the lowest severity:
0 emergencies:
1 alerts
2 critical
3 errors
4 warnings
5 notices
6 informational
7 debugging
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
System is unusable
Action must be taken immediately
Critical conditions
Error conditions
Warning conditions
Normal, but significant, conditions
Informational messages
Debug-level messages
C613-50007-01 REV B