Introduction; Interface Tunnel - Allied Telesis SwitchBlade x908 Series Software Reference Manual

IPv6to4 Tunneling Commands

Introduction

This chapter contains AlliedWare Plus

interface tunnel

interface tunnel Command
Use this command to create a new tunnel interface, which is identified by an integer (1-145).
This command is also used to enter interface configuration mode for existing tunnel interfaces.
Use the no parameter to destroy a previously created tunnel interface.
Syntax
interface tunnel <1-145>
no interface tunnel <1-145>
Disabled
Default
Global Configuration mode
Mode
This command creates a new tunnel interface to configure in Interface mode.
Usage
Example
tunnel dscp
Related Commands
tunnel mode ipv6ip
tunnel source
tunnel ttl
27.2
New vs_531 %flag
awplus# configure terminal
awplus(config)# interface tunnel 100
awplus(config-if)#
awplus# configure terminal
awplus(config)# no interface tunnel 100
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
TM
commands related to IPv6to4 automatic tunneling.
IPv6to4 Tunneling Commands Use this command to create a new tunnel interface, which is identified by an integer (1-145).
C613-50007-01 REV B