Vlan - Allied Telesis SwitchBlade x908 Series Software Reference Manual

vlan

This command creates VLANs, assigns names to them, and enables or disables them. Specifying
the disable state causes all forwarding over the specified VLAN ID to cease. Specifying the
enable state allows forwarding of frames on the specified VLAN.
The no version of this command destroys the specified VLANs.
Syntax
vlan <vid> [name <vlan-name>] [state {enable|disable}]
vlan <vid-range> [state {enable|disable}]
no vlan {<vid>|<vid-range>}
Parameter
<vid>
<vlan-name>
<vid-range>
enable
disable
By default, VLANs are enabled when they are created.
Default
VLAN Database Configuration mode
Mode
Examples
awplus(config-vlan)#vlan 45 name accounts state enable
vlan database
Related Commands
show vlan
C613-50007-01 REV B
Description
The VID of the VLAN that will be enabled or disabled <2-4094>.
The ASCII name of the VLAN. Maximum length: 32 characters.
Specifies a range of VLAN identifiers.
Sets VLAN into an enable state.
Sets VLAN into a disable state.
awplus# configure terminal
awplus(config)# vlan database
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
VLAN Commands
17.17