Log Host Time - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Logging Commands

log host time

Configures the time used in messages sent to a remote syslog server. Use local if the syslog
server is in the same time zone as this device. Messages will display the time as on the local
device when the message was generated. Use offset if the syslog server is in a different time
zone to this device. Specify the time offset of the syslog server, in hours. Messages will display
the time they were generated on this device but converted to the time zone of the syslog
server. The default is local.
Syntax
log host <ip-address> time {local|offset {plus|minus}<0-24>}
Parameter
log
host
<ip-address>
time
local
offset
plus
minus
<0-24>
Global Configuration mode
Mode
To send messages to the remote syslog server with IP address 10.32.16.21, with the time
Examples
information converted to the time zone of the syslog server, which is 3 hours ahead of this
device, use the command:
awplus(config)#
show log config
Validation
Commands
default log buffered
Related Commands
log host
10.26
Description
Logging control
Send log messages to a remote syslog server
The IP address of a remote syslog server, entered in the form A.B.C.D
Specify the time difference between the remote syslog server and the
device being configured.
The device is in the same time zone as the remote syslog server
The device is in a different time zone to the remote syslog server. Use the
plus or minus keywords and specify the difference in hours.
Negative offset
Positive offset
World Time zone offset in hours
log host 10.32.16.21 time offset plus 3
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B