Platform Enhancedmode - Allied Telesis SwitchBlade x908 Series Software Reference Manual

platform enhancedmode

This command rearranges memory in the silicon so that it can either store QoS traffic class
counters, or store a greater number of routes than usual. For the enhanced mode to take
effect, you must restart the device after entering this command.
The switch remains in enhanced mode until you change it with a no platform
enhancedmode.
The no parameter restores the memory to the default state. You must restart the device after
entering this command for it to take effect.
This feature is disabled by default.
Syntax
platform enhancedmode {nexthop|qoscounters}
no platform enhancedmode
Parameter
nexthop
qoscounters
Global Configuration mode
Mode
Note that the qoscounters option reduces the maximum number of available traffic classes.
Usage
You must set the qoscounters option before you configure QoS storm protection.
To turn monitoring of QoS traffic class counters on, use the command:
Example
To restore the silicon memory so that the QoS traffic counters are no longer monitored, use
the command:
To increase the size of the nexthop table, use the command:
To restore the silicon memory so that the nexthop table returns to its original size, use the
command:
show platform
Related Commands
show running-config
C613-50007-01 REV B
Description
Increases the size of the nexthop table. If you specify this, the
silicon stores up to 5000 individual routes (nexthops). The
maximum number of multicast groups and traffic classes is reduced.
Enables QoS counters. If you specify this, the silicon monitors QoS
counters for traffic classes. The maximum number of traffic classes
is reduced. You must set this option before you configure QoS
storm protection.
awplus(config)# platform enhancedmode qoscounters
awplus(config)# no platform enhancedmode
awplus(config)#platform enhancedmode nexthop
awplus(config)# no platform enhancedmode
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Switching Commands
15.19