Chapter 8. System Configuration And Monitoring Commands; Introduction; Banner Exec - Allied Telesis SwitchBlade x908 Series Software Reference Manual

System Configuration and Monitoring Commands

Introduction

This chapter provides an alphabetized reference of AlliedWare Plus
configuring and monitoring the system.

banner exec

This command configures the Exec mode banner that is displayed on the console after you
login. The banner exec default command restores the Exec banner to the default banner. Use
the no banner exec command to disable the Exec banner and remove the default Exec banner.
Syntax
banner exec <banner-text>
banner exec default
no banner exec
Global Configuration mode
Mode
By default, the AlliedWare Plus version and build date is displayed at console login, such as:
Default
AlliedWare Plus (TM) 5.3.1 07/27/08 00:44:25
To configure a Exec mode banner after login, issue the following commands:
Example
To restore the default Exec mode banner after login, issue the following commands:
8.2
awplus#configure terminal
awplus(config)#banner exec enable to move to Priv Exec mode
awplus(config)#exit
awplus#exit
awplus login: manager
Password:
enable to move to Priv Exec mode
awplus>
awplus#configure terminal
awplus(config)#banner exec default
awplus(config)#exit
awplus#exit
awplus login: manager
Password:
AlliedWare Plus (TM) 5.3.1 11/14/08 13:03:59
awplus>
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
TM
OS commands for
C613-50007-01 REV B