Clear Bgp - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands

clear bgp *

Use this command to reset the BGP connection for all peers.
Syntax clear bgp * [<in>|out|<soft>]
Parameter
*
<in>
in
prefix-filter
out
<soft>
in
out
Privileged Exec mode
Mode
Example
awplus#
awplus#
38.30
Description
Clears all bgp peers
in [prefix-filter]
Indicates that incoming advertised routes will be cleared.
Specifies that a prefix-list will be sent, by the ORF mechanism, to those
neighbors with which the ORF capability has been negotiated. The
neighbors will be triggered to resend updates, which match the prefix-
list filter, to the local router. The local router will then perform a soft
reconfiguration.
Indicates that outgoing advertised routes will be cleared.
soft [in |out]
Soft inbound reset causes the neighbors to resend all their updates to
the local switch, without resetting the connection or clearing the
entries in the local switch. So, the local switch stores new updates, and
uses them to systematically replace existing table entries. This process
can use a considerable amount of memory.
Soft outbound reset causes the switch to simply resend all its updates
to the specified neighbor(s), without resetting the connection, or
clearing table entries.
clear bgp * soft in
clear bgp ipv6 * in prefix-filter
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1 C613-50007-01 REV B