Neighbor Capability Dynamic - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands

neighbor capability dynamic

Use this command to enable the dynamic capability for a specific peer.
Use the no parameter with this command to disable the dynamic capability.
Syntax
neighbor <neighborid> capability dynamic
no neighbor <neighborid> capability dynamic
Parameter
<neighborid>
Disabled
Default
Router mode
Mode
This command allows a BGP speaker to advertise or withdraw an address family capability to a
Usage
peer in a non-disruptive manner.
Example
awplus(config-router)#
38.58
Description
{<ip-address>|<tag>}
<ip- The address of an IPv4 BGP neighbor, in dotted decimal
address>
notation A.B.C.D.
<tag> Name of an existing peer-group. For information on how to
create peer groups, refer to the
(adding a neighbor) command on page
neighbor remote-as command on page
this parameter is used with a command, the command
applies on all peers in the specified group.
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.10.1 capability dynamic
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
neighbor peer-group
38.75, and
38.79. When
C613-50007-01 REV B