Neighbor Peer-Group (Adding A Neighbor) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

neighbor peer-group (adding a neighbor)

Use this command to add a neighbor to an existing peer-group.
Use the no parameter with this command to disable this function.
Syntax
neighbor <ip-address> peer-group <tag>
no neighbor <ip-address> peer-group <tag>
Parameter
<ip-address>
<tag>
Router mode and Address Family [ipv4 unicast | ipv4 multicast ] mode
Mode
Use this command to add Neighbors with the same update policies to a peer group. This
Usage
facilitates the updates of various policies, such as, distribute and filter lists. The peer-group is
then configured easily with any of the neighbor commands. Any changes made to the peer
group affect all members.
To create a peer-group use the neighbor peer-group create command and then use this
command to add neighbors to the group.
This example shows a new peer-group group1 and the adding of a neighbor 10.10.0.63
Example
to the group.
awplus(config-router)#
awplus(config-router)#
C613-50007-01 REV B
Description
Specifies the IPv4 address of the BGP neighbor, entered in the format
A.B.C.D.
Name of the peer-group
awplus# configure terminal
awplus(config)# router bgp 10
neighbor group1 peer-group
neighbor 10.10.0.63 peer-group group1
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
BGP Commands
38.75