Loop-Protection Action - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Switching Commands

loop-protection action

loop-protection action Command
Syntax
loop-protection action {learn-disable|link-down|log-only|
no loop-protection action
Parameter
learn-disable
link-down
log-only
port-disable
vlan-disable
none
no
Port / Aggregator Interface mode
Mode
loop-protection action vlan-disable
Default
To disable an interface, and bring the link down, when a network loop is detected, use the
Example
command:
Note:
15.10
new vs_531 %flag
port-disable|vlan-disable|none}
Description
Disable MAC address learning
Block all traffic on a port (or aggregated link) that detected the loop, and
take down the link.
Details of loop conditions are logged. No action is applied to the port (or
aggregated link).
Block all traffic on interface for which the loop occurred, but keep the link
in the up state.
Block all traffic for the VLAN on which the loop traffic was detected.
Note that setting this parameter will also enable ingress filtering.
This is the default action.
Applies no protective action.
This variant of the command resets the loop protection actions to default
values.
awplus(config-if)#
Currently the learn-disable parameter is not supported for 5.3.1. If specified, an
error message will be displayed.
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Switching Commands This command to specify the protective action to apply when a network loop is detected. This command specifies the protective action to apply when a network loop is detected.
loop-protection action link-down
C613-50007-01 REV B