Distance (Ospf) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

distance (ospf)

This command sets the administrative distance for OSPF routes based on the route type. Your
device uses this value to select between two or more routes to the same destination from two
different routing protocols. The route with the smallest administrative distance value is added
to the Forwarding Information Base (FIB). See
more information.
Use this command to set the distance for an entire category of OSPF routes, rather than the
specific routes that pass an access list.
Use the command distance <1-255>, with no other parameter, to set the same distance for all
OSPF route types.
The no form sets the administrative distance for all OSPF route types to the default of 110.
Syntax distance <1-255>
distance ospf
no distance {ospf|<1-255}
Parameter
<1-255>
external
inter-area
intra-area
Router mode
Mode
To set the following administrative distances for route types in OSPF 100:
Examples
■
■
■
use the commands:
awplus(config-router)#
To set the administrative distance for all routes in OSPF 100 back to the default of 110, use the
commands:
awplus(config-router)#
C613-50007-01 REV B
{external <1-255>|inter-area <1-255>|intra-area <1-255>}
Description
The administrative distance value you are setting for the OSPF route
type, or for all OSPF route types.
Sets the distance for routes from other routing domains, learned by
redistribution.
Sets the distance for all routes from one area to another area.
Sets the distance for all routes within an area.
20 for inter-area routes
10 for intra-area routes
40 for external routes
awplus(config)#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
"Administrative Distance" on page 29.4
router ospf 100
distance ospf inter-area 20 intra-area 10
external 40
router ospf 100
no distance ospf
OSPF Commands
for
36.25