Set Ip Next-Hop - Allied Telesis SwitchBlade x908 Series Software Reference Manual

set ip next-hop

Use this command to add a next-hop set clause to a route map entry.
When a route or BGP update message matches the route map entry, the device sets the
route's next hop to the specified IP address.
Use the no parameter to remove the set clause.
Syntax
set ip next-hop <ip-address>
no set ip next-hop [<ip-address>]
Parameter
<ip-address>
Route-map mode
Mode
Use this command to set the next-hop IP address to the routes.
Usage
This command is valid for BGP update messages, and OSPF and RIP routes.
To use entry 3 of the route map called mymap to give matching routes a next hop of
Examples
10.10.0.67, use the commands:
awplus(config-route-map)#
match ip next-hop
Related Commands
route-map
show route-map
C613-50007-01 REV B
Description
The IP address of the next hop, entered in the form A.B.C.D.
awplus#
awplus(config)#
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
configure terminal
route-map mymap permit 3
set ip next-hop 10.10.0.67
Route Map Commands
39.29