Neighbor Enforce-Multihop - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands

neighbor enforce-multihop

Use this command to enforce the requirement that BGP neighbors form multihop connections.
Use the no parameter with this command to turn off this feature.
Syntax
neighbor <neighborid> enforce-multihop
no neighbor <neighborid> enforce-multihop
Parameter
<neighborid>
Router mode
Mode
Example
awplus(config-router)#
awplus(config-router)#
38.68
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.0.34 remote-as 20
neighbor 10.10.0.34 enforce-multihop
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted decimal
notation A.B.C.D.
Name of an existing peer-group. For information on how to
create peer groups, refer to the
(adding a neighbor) command on page
neighbor remote-as command on page
this parameter is used with a command, the command
applies on all peers in the specified group.
neighbor peer-group
38.75, and
38.79. When
C613-50007-01 REV B