Neighbor Shutdown - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands

neighbor shutdown

Use this command to disable a peering relationship with a neighbor.
Use the no parameter with this command to re-enable the neighbor.
Syntax
neighbor <neighborid> shutdown
no neighbor <neighborid> shutdown
Parameter
<neighborid>
Router mode
Mode
This command shuts down any active session for the specified neighbor and clears all related
Usage
routing data.
Example
awplus(config-router)#
awplus(config-router)#
38.86
Description
{<ip-address>|<tag>}
<ip-
address>
<tag>
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 10.10.0.72 shutdown
awplus# configure terminal
awplus(config)# router bgp 10
no neighbor 10.10.0.72 shutdown
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted decimal
notation A.B.C.D.
Name of an existing peer-group. For information on how
to create peer groups, refer to the
group (adding a neighbor) command on page
38.75, and neighbor remote-as command on page
38.79. When this parameter is used with a command, the
command applies on all peers in the specified group.
neighbor peer-
C613-50007-01 REV B