Ip Rip Receive-Packet - Allied Telesis SwitchBlade x908 Series Software Reference Manual

ip rip authentication key-chain
Related commands
ip rip authentication mode

ip rip receive-packet

Use this command to configure the interface to enable the reception of RIP packets.
Use the no parameter with this command to disable this feature.
Syntax
ip rip receive-packet
no ip rip receive-packet
Receive-packet is enabled
Default
Interface mode
Mode
This example shows packet receiving being turned on for interface VLAN3.
Example
awplus(config-if)#
ip rip send-packet
Related Commands
C613-50007-01 REV B
awplus# configure terminal
awplus(config)# interface VLAN3
ip rip receive-packet
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
RIP Commands
32.15