Chapter 19. Spanning Tree Commands; Introduction; Cisco-Interoperability (Mstp) - Allied Telesis SwitchBlade x908 Series Software Reference Manual

Spanning Tree Commands

Introduction

This chapter lists the commands that are used to configure RSTP, STP or MSTP. For
information about spanning trees, including configuration procedures, see
Spanning Tree Introduction: STP, RSTP, and MSTP

cisco-interoperability (MSTP)

Use this command to enable/disable Cisco-interoperability for MSTP.
Use this command for MSTP only.
Syntax
cisco-interoperability {enable|disable}
Parameter
enable
disable
If this command is not used, Cisco interoperability is disabled.
Default
Global Configuration mode
Mode
For compatibility with certain Cisco devices, all devices in the switched LAN running the
Usage
AlliedWare Plus
AlliedWare Plus
classify a region are the region name and revision level. VLAN to instance mapping is not used
to classify regions when interoperating with Cisco.
To enable Cisco interoperability on a Layer-2 switch:
Examples
awplus(config)#
To disable Cisco interoperability on a Layer-2 switch:
awplus(config)#
19.2
Description
Enable Cisco interoperability for MSTP.
Disable Cisco interoperability for MSTP.
TM
Operating System must have Cisco-interoperability enabled. When the
TM
Operating System is interoperating with
awplus# configure terminal
cisco-interoperability enable
awplus# configure terminal
cisco-interoperability disable
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
Chapter 18,
Cisco, the only criteria used to
C613-50007-01 REV B