Tunnel Dscp - Allied Telesis SwitchBlade x908 Series Software Reference Manual

tunnel dscp

tunnel dscp Command
Use this command to configure the value (0-63) to use for the IPv4 DSCP (Differentiated
Services Code Point) field in the IPv4 header that encapsulates the tunneled IPv6 packets.
By default the IPv4 DSCP field value is 0.
Use the no parameter to reset the IPv4 DSCP field to the default value (0).
Syntax
tunnel dscp <0-63>
no tunnel dscp
The default IPv4 DSCP field value is 0.
Default
Interface mode
Mode
This command controls the IPv4 DSCP field in the IPv4 headers that are prepended (or
Usage
prefixed) to the tunneled IPv6 packets.
Example
interface tunnel
Related Commands
tunnel mode ipv6ip
tunnel source
tunnel ttl
C613-50007-01 REV B
New vs_531 %flag
awplus# configure terminal
awplus(config)# interface tunnel 100
awplus(config-if)# tunnel source 192.168.11.1
awplus(config-if)# tunnel dscp 10
awplus# configure terminal
awplus(config)# interface tunnel 100
awplus(config-if)# tunnel source 192.168.11.1
awplus(config-if)# no tunnel dscp
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
IPv6to4 Tunneling Commands Use this command to configure the value (0-63) to use for the IPv4 DSCP (Differentiated Services Code Point) field in the IPv4 header that encapsulates the tunneled IPv6 packets.
IPv6to4 Tunneling Commands
27.3