Neighbor Description - Allied Telesis SwitchBlade x908 Series Software Reference Manual

BGP Commands

neighbor description

Use this command to associate a description with a neighbor.
Use the no parameter with this command to remove the description.
Syntax
neighbor <neighborid> description <description>
no neighbor <neighborid> description [<description>]
Parameter
<neighborid>
<description>
Router mode
Mode
Example
awplus(config-router)#
38.64
Description
{<ip-address>|<tag>}
<ip-address>
<tag>
Up to 80 characters of text describing the neighbor.
awplus# configure terminal
awplus(config)# router bgp 10
neighbor 1.2.3.4 description Backup router for
sales.
Software Reference for SwitchBlade® x908, x900 and x600 Series Switches
TM
AlliedWare Plus Operating System - Software Version 5.3.1
The address of an IPv4 BGP neighbor, in dotted
decimal notation A.B.C.D.
Name of an existing peer-group. For information on
how to create peer groups, refer to the
peer-group (adding a neighbor) command on
page 38.75, and neighbor remote-as
command on page 38.79. When this parameter
is used with a command, the command applies on all
peers in the specified group.
neighbor
C613-50007-01 REV B